Epoxy Resin Necklace DIY

Resin chain necklace – this is how it works:

Preparation: Have all materials ready. Note that you should work at room temperature and the humidity should not exceed 70%. All materials and tools should also be at room temperature.

Step 1: Put on the disposable gloves and mix our EPODEX PRO system according to the instructions in a ratio of 2:1. Stir well until no more streaks are visible.

Step 2: Pour the finished resin into a mixing cup. Stir the resin again thoroughly after repotting.

Step 3: Now pour the clear resin into the silicone mould.

Step 4: Now you can place the glitter particles, flowers or pigments in the resin according to your taste.

Step 5: After 24 hours the resin has hardened and you can take the pendant out of the mould.

Step 6: Now the eyelet must be bent open with pliers. Then you can hang up the pendant.

Step 7: Now the pendant is ready and can be pulled onto the chain.

Step 8: If the silicone mould has left streaks, you can polish them away with EPODEX polishing paste and a microfibre cloth.